NcStar AK-47 Receiver Cover with Tri-Rail

51

| Write a Review

Ratings Snapshot

3.5

out of 5

5 (22)

4 (11)

3 (3)

2 (1)

1 (14)

Would recommend this product.

70.6%

SKU: 111-NCS-MTAK
UPC: 814108011918
Manufacturer: NcStar
MFG#: NcStar MTAK

Fits well with minor adjustments and tightens securely so scope doesn't move.

Great fitmant and delivery timing

In short, it doesn’t fit my micro Draco. Once I start to tighten the screws the cover pops off. I struggled with this for almost a half an hour. I will be returning this item.

I purchased this dust cover and was also given a YOUTUBE link to refer to in the event I needed to make small adjustments. This product did fit my Arsenal Ak47 and AK74, but after firing a couple rounds the dust cover would displace itself almost falling off. Now this product sits on a shelf collecting dust. Complete disappointment! I guess you get what you pay for.

I tried to get it to fit my ak-47 I recently purchased and I could not get it to fit. Operator error I was thinking on my part so I took it to a local shop that build custom rifles and they even shaved it down and still couldn’t get it to fit. Complete waist of time. The price wasn’t a big deal I just wanted something quick but atleast if you buy it let the thing fit and do what it is supposed to do. Never buying anything from that company again

After buying it and waiting for it to come in the mail. It did not fit my VSKA AK47. I wouldn’t recommend buying it. The back of the slide cover is weird and it might not fit yours.

When this was made the release hole was 1/8" too low so I scribed out the proper spot and got out my Dremel with a cut off wheel and cut the release hole up 1/8" then cut out a 'heavy' piece of aluminum to fill the lower part of the hole an 1/8th inch JB Welded it in place on the inside and filled the outside with JB Weld filed and painted it and it now fits like a glove. I would recommend this product but only if you know how to do some metal working like I did above.

When this was made the release hole was 1/8" too low so I scribed out the proper spot and got out my Dremel with a cut off wheel and cut the release hole up 1/8" then cut out a 'heavy' piece of aluminum to fill the lower part of the hole an 1/8th inch JB Welded it in place on the inside and filled the outside with JB Weld filed and painted it and it now fits like a glove. I would recommend this product but only if you know how to do some metal working like I did above.

Does not work at all. Causes guide rail to get stuck back every time.

Bought this but didn’t fit, dimensions are off in the back and dust cover latch hole is too low. I shaved it to length I needed in front, shaved out material for dust cover latch, it goes on now but must force it down because angle is too steep and it forces button forward from inside. Need to add material to the bottom of latch hole now since it was too low and shaved it higher. The rail is off center a few degrees to the right, Need to bend cover inward on the bottom sides because it sits too wide of receiver, the screws do nothing. Just junk, should have purchased the more expensive TWS one. I just liked that I could have kept old iron sights, and it had a middle valley for co-witnessing, but I never got it to go on my gun. It said “Made in China” but didn’t even fit my Chinese (Norinco) AK, how does that even happen. No wonder why it is only $20

It doesn’t fit......had to dremel some of it off....they should take a lot less money when you have to do all the work.

There is too much play in the cover. When I let go, it slides back and off the top. Not good.