My Cart: 0 item(s)
The most striking feature of the MUZZELITE bullpup stock, when attached to your action, is the overall length of 26-1/2". This allows you to carry the rifle with much greater mobility. Whether your sport is hunting or plinking, the MUZZELITE bullpup stock will convert a long rifle into a compact weapon system in just a matter of minutes!
The stock itself has fixed sights which are adjustable for windage and elevation. The windage is done with the rear sight and the elevation is done with the front sight. The stock also comes equipped with a scope mount which attaches in the handle.
Construction is of fiberglass reinforced plastic. Required Allen wrench is included.
Please note:
- Bullpup stocks cannot be fired in a left handed position and are therefore only suitable for right handed shooters.
- Some high capacity magazines may not clear the pistol grip.
- No order to Canada
WARNING
To comply with Federal Law, not only must your rifle have a 16 inch or longer barrel, but the overall length of the weapon must be 26 inches or greater. Placing a rifle with a relatively short barrel in a Muzzelite stock may result in violation of the 26 inch length restriction, even though the barrel length remains in compliance. Muzzelite stocks are 23 inches long, and so require a minimum of 3 inches of barrel extension beyond the stock.
It is your obligation to measure the overall length of your weapon, out of the stock, to ensure it will remain in compliance with the 26 inch length restriction when placed in a Muzzelite stock. If your weapon has a barrel that complies, but the overall weapon length will not meet the 26 inch restriction if placed in a Muzzelite stock, do NOT, repeat NOT, assemble your weapon in the Muzzelite stock.
Remember that these restrictions are only those imposed by Federal law. Some states or localities may impose additional restrictions. It is your obligation to research ALL laws applicable to your locale, and to remain in compliance with ALL applicable laws, not just Federal restrictions.
This notice does not apply to any NFA weapon to which length restrictions are inapplicable, which has been lawfully approved for possession by the BATFE and local governments.
Again, it is your obligation to ensure that your weapon remains in compliance with ALL applicable length restrictions. Muzzelite is not responsible for your assembly of non-compliant weapons.
More Bullpup Links:
- Ruger 10/22 bullpup
- 10/22 bullpup
- ruger 10/22 takedown stock
- Ruger 10/22 bullpup stock kit
- Ruger 10/22 chassis bullpup
- 10/22 bullpup stock
- 10/22 bullpup rifle kit
- Bullpup 22
- Ruger 10/22 conversion kit bullpup
- Bullpup 10/22
- 10 22 bullpup
- Ruger 10/22 bullpup stock
- Ruger 1022 bullpup conversion
- 1022 bullpup
- 22lr bullpup conversion
WARNING: This product can expose you to Lead, which is known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to - www.P65Warnings.ca.gov.
Customer Ratings & Reviews
Ratings Snapshot
out of 5
5
(1)
4
(1)
3
(0)
2
(0)
1
(1)
Would recommend this product.
66.7%
out of 5
5
(1)
4
(1)
3
(0)
2
(0)
1
(1)
Would recommend this product.
66.7%
3 Total Reviews
- 1
bad product
bass
Location: 238 sw kentwood rd psl fl
Date:
September 5, 2024
part did not fit the marlin camp9
Verified Buyer
Pretty Good Option
Scio Dad
Location: OREGON
Date:
December 20, 2018
It's a good product for the money. It does, however, require some modifications and a little tweaking. I had to do some trimming to get the barrel to fit properly but it was no big deal. The main issue was the trigger. The factory trigger on the Camp 9 is pretty hard to pull. The plastic piece that extends the trigger pull does not extend far enough beyond the trigger guard to easily pull. I filed the back side of the trigger guard and the inner surface for a smoother slide and better clearance. I also ended up making a hard rubber pad for the trigger to make it not hurt when pulling. All in all I like the stock and it makes the rifle much nicer to use.
Recommended
BULLPUP Camp 9
RAF
Location: UT
Date:
May 21, 2012
Body is solid and fit well with small modification to fit barrel properly, easy to assemble. Shipping was fast and accurate.
Recommended
3 Total Reviews
- 1
