MUZZELITE PLUS
BULLPUP RIFLE STOCK
for the
MARLIN 70 MAGAZINE FED
OPTIONAL: Muzzelite Bags |
|
click to enlarge |
The most striking feature of the MUZZELITE bullpup stock, when attached to your action, is the overall length of 26-1/2". This allows you to carry the rifle with much greater mobility. Whether your sport is hunting or plinking, the MUZZELITE bullpup stock will convert a long rifle into a compact weapon system in just a matter of minutes!
The stock itself has fixed sights which are adjustable for windage and elevation. The windage is done with the rear sight and the elevation is done with the front sight. The stock also comes equipped with a scope mount which attaches in the handle.
Construction is of fiberglass reinforced plastic. Required Allen wrench is included.
Please note:
- Bullpup stocks cannot be fired in a left handed position and are therefore only suitable for right handed shooters.
- Some high capacity magazines may not clear the pistol grip.
- No order to Canada
WARNING
To comply with Federal Law, not only must your rifle have a 16 inch or longer barrel, but the overall length of the weapon must be 26 inches or greater. Placing a rifle with a relatively short barrel in a Muzzelite stock may result in violation of the 26 inch length restriction, even though the barrel length remains in compliance. Muzzelite stocks are 23 inches long, and so require a minimum of 3 inches of barrel extension beyond the stock.
It is your obligation to measure the overall length of your weapon, out of the stock, to ensure it will remain in compliance with the 26 inch length restriction when placed in a Muzzelite stock. If your weapon has a barrel that complies, but the overall weapon length will not meet the 26 inch restriction if placed in a Muzzelite stock, do NOT, repeat NOT, assemble your weapon in the Muzzelite stock.
Remember that these restrictions are only those imposed by Federal law. Some states or localities may impose additional restrictions. It is your obligation to research ALL laws applicable to your locale, and to remain in compliance with ALL applicable laws, not just Federal restrictions.
This notice does not apply to any NFA weapon to which length restrictions are inapplicable, which has been lawfully approved for possession by the BATFE and local governments.
Again, it is your obligation to ensure that your weapon remains in compliance with ALL applicable length restrictions. Muzzelite is not responsible for your assembly of non-compliant weapons.
Customer Ratings & Reviews
- 1
Cool bullpup shell for your old model 70
Must have some skills to make it fit & work properly. I'm a 30 year veteran Gunsmith and it took me a three hour tour to make it fit my rifle. First I had to remove some plastic behind the magwell to fit my promag 25 round magazine's. Then I had to shaved plastic off the trigger bar to fit around the receiver and to make clearance for the hi capacity magazines. The stock 7 and 10 round mags fit with no modifications but since the 25 rd. promags have a wider housing you must modify the plastic behind the magwell. I also installed a Mcarbo reduced weight trigger spring kit and it reduced the factory 7# trigger pull to a 4# trigger pull. Sweet!!! I replaced the firing pin / recoil spring and recoil buffer since M70's are old guns you might as well replace these parts while you have it disassembled. Greased the trigger bar and sanded some areas that were rubbing along the trigger bar and trigger housing. This stock makes the gun shorter, lighter and easier to acquire targets quickly & with a holographic red/green optic turns the old model 70 into a futuristic/SYFY weapon and still a 🐿 🐿 🐿 🐿 worst nightmare. Bottom line: it works, looks cool and if you have some skills/patience & a Marlin model 70 then this stock makes a cool DIY project during these uncertain times 😷 So buy one Stay Home and Stay Safe 🗽
- 1