EGW Red Dot Sight Mount For DeltaPoint Pro with Sig Sauer P210A Target
Not Yet Rated | Write the First Review SKU: 198-49398
UPC: 841370116669
MFG#: EGW 49398

EGW Dovetail Sight Mount For the DeltaPoint Pro (fits Bushnell RXS-250/100, Shield RMS/RMSc/SMS & more) with the Sig Sauer P210A Target

This Mount Fits:

• Sig P210A Target

This mount for the P210 is made specifically for the U.S. made P210s. The front of the mount will need to be cross drilled to fit each individual gun. The pin from the factory rear sight may be reused as well.

The hole dimension for the cross hole is 2.04mm. There are 2.04mm drill bits available from sites like Grainger, but you may also be able to use a 5/64" bit to mark the hole on the mount and a 3/32" bit to drill the hole. Sig uses a 2mm coiled spring pin to hold the original sight in place.

Material: 7075 Aluminum
Coating: Matte Black Hardcoat
Overall Length: 1.604"
Overall Width: .99"
Mounting Hardware: (2) 6-32 Button Head Screws, (1) 6-32 X 3/16 Set Screw
Red Dot Fitment:

• Bushnell RXS-100
• Bushnell RXS-250
• Bushnell RXU-200
• Crimson Trace CTS-1500
• Holosun 407K*
• Holosun 507K*
• Holosun EPS Carry*
• Jpoint
• Leupold DeltaPoint Pro
• Optima
• Redfield Accelerator
• Shield RMS
• Shield RMSc
• Shield SMS
• Sig Romeo Zero
• Vortex Defender-CCW
• Vortex Defender-ST
• Vortex Defender-XL

(*with Modification, the rear two locater pins on the plate must be filed off in order to allow the 407K/507K to fit.)

EGW red dot mounts  are meant to be installed from the left to the right (with the muzzle facing forward). The dovetail has a progressive taper to allow for easier install.

Simply remove the rear sight on your gun and replace it with our mount in order to mount your Leupold DeltaPoint Pro, JPoint, Redfield Accelerator, or Optima red-dot sight. You can take our mount off and replace your rear sight at any time. Mounting hardware included.

Installation Instructions
- Remove the rear sight*
- Install the EGW Sight Mount
- Tighten set screw (if applicable)
- Place the red dot sight on the EGW Sight Mount
(placing a small piece of paper between the red dot sight and the sight mountwill make for easier removal and will keep Loctite off of the red dot sight.)
- Apply blue Loctite to the provided mounting screws
- Torque mounting screws to 15in/lbs

Modification of your firearm may nullify the manufacturer's warranty.
This product should be installed and checked by a qualified gunsmith.
No liability is expressed or implied for damage or injury which may result from improper installation or use of this product.

The distinction between inferior quality and premium Sig P210A Target Red Dot Mount is undeniable. At MSP, we only offer Sig P210A Target Accessories from the most trusted brands like Evolution Gun Works. Buy with confidence that we stand behind the product we sell.