EGW Dovetail Sight Mount For DeltaPoint Pro with Colt Gold Cup, Python, Anaconda
Not Yet Rated | Write the First Review SKU: 198-49421
UPC: 841370107261
MFG#: 49421

EGW Dovetail Sight Mount For the DeltaPoint Pro (fits Bushnell RXS-250/100, Shield RMS/RMSc/SMS...) for Colt Gold Cup, Python, Anaconda

Mounting Hardware is Included

This mount fits:

• Colt Gold Cup
• Colt Trooper Mark 3
• Colt Python (does NOT fit 2020 and newer models)
• Colt Anaconda (does NOT fit 2020 and newer models)*

This is for Colt models with the Elliason style adjustable rear sight.

The elevation screw from the original rear sight is re-used in the center hole on this mount unless you have an Anaconda. An extra screw is available for purchase below as well.

*Anacondas require a new elevation screw due to the design of the elevation screw supplied with the gun.

Material: 7075 Aluminum
Coating: Matte Black Hardcoat
Overall Length: 1.604"
Overall Width: .99"
Mounting Hardware: (2) 6-32 Button Head Screws, (1) 6-32 X 3/16 Set Screw
Red Dot Fitment:

• Bushnell RXS-100
• Bushnell RXS-250
• Bushnell RXU-200
• Crimson Trace CTS-1500
• Holosun 407K*
• Holosun 507K*
• Holosun EPS Carry*
• Jpoint
• Leupold DeltaPoint Pro
• Optima
• Redfield Accelerator
• Shield RMS
• Shield RMSc
• Shield SMS
• Sig Romeo Zero
• Vortex Defender-CCW
• Vortex Defender-ST
• Vortex Defender-XL

(*with Modification, the rear two locater pins on the plate must be filed off in order to allow the 407K/507K to fit.)

Simply remove the rear sight on your gun and replace it with our mount in order to mount your Leupold DeltaPoint Pro, JPoint, Redfield Accelerator, or Optima red-dot sight. You can take our mount off and replace your rear sight at any time. Mounting hardware included.

Installation Instructions
- Remove the rear sight*
- Install the EGW Sight Mount
- Tighten set screw (if applicable)
- Place the red dot sight on the EGW Sight Mount
(placing a small piece of paper between the red dot sight and the sight mountwill make for easier removal and will keep Loctite off of the red dot sight.)
- Apply blue Loctite to the provided mounting screws
- Torque mounting screws to 15in/lbs

Modification of your firearm may nullify the manufacturer's warranty.
This product should be installed and checked by a qualified gunsmith.
No liability is expressed or implied for damage or injury which may result from improper installation or use of this product.

The distinction between inferior quality and premium scope mount is undeniable. At MSP, we only offer red dot mounts from the most trusted brands like Evolution Gun Works. Buy with confidence that we stand behind the product we sell.